Pioneer DEH-P480MP Owner's Manual - Page 37
Adjusting initial settings, Setting the clock, Switching the warning tone, Switching the auxiliary - head unit
UPC - 012562776804
View all Pioneer DEH-P480MP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Initial Settings Section 09 English Adjusting initial settings 1 2 Press c or d to select the segment of the clock display you wish to set. Pressing c or d will select one segment of the clock display: HourMinute As you select segments of the clock display the segment selected will blink. Using the initial settings, you can customize various system settings to achieve optimal performance from this unit. 1 Function display Shows the function status. 1 Press SOURCE and hold until the unit turns off. 2 Press SOURCE and hold again until the clock appears in the display. 3 Press FUNCTION to select one of the initial settings. Press FUNCTION repeatedly to switch between the following settings: ClockWARN (warning tone)AUX1 (auxiliary input1)AUX2 (auxiliary input2)R-SP (rear output and subwoofer controller) Use the following instructions to operate each particular setting. # To cancel initial settings, press BAND. # You can also cancel initial settings by holding down SOURCE until the unit turns off. 3 Press a or b to set the clock. Pressing a will increase the selected hour or minute. Pressing b will decrease the selected hour or minute. Switching the warning tone If the front panel is not detached from the head unit within five seconds of turning off the ignition, a warning tone will sound. You can turn off the warning tone. 1 Press FUNCTION to select WARN. Press FUNCTION repeatedly until WARN appears in the display. 2 Press a or b to turn WARN on or off. Pressing a or b will turn WARN on or off and that status will be displayed (e.g., WARN :ON). Setting the clock Use these instructions to set the clock. 1 Press FUNCTION to select clock. Press FUNCTION repeatedly until clock appears in the display. Switching the auxiliary setting Auxiliary equipments connected to this unit can be activated individually. Set each AUX source to ON when using. About connecting or using auxiliary equipments, refer to Using the AUX source on page 39. En 37