Pioneer DEH-P640 Other Manual - Page 2

Connecting the Units 7 When using a Subwoofer without using a different amp (sold separately) 16 cm [5/8 in] Front output Multi-CD player (sold separately) Subwoofer output Antenna jack IP-Bus input(Blue) IP-BUS cable Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Yellow To terminal always supplied with power regardless of ignition switch position. Red To electric terminal controlled by ignition switch (12 V DC) ON/OFF. Orange/white To lightnig switch terminal. Black (ground) To vehicle (metal) body. Fuse This Product Blue/white To system control terminal of the power amp or Auto-antenna relay control terminal (max. 300 mA 12 V DC). + Front speaker ≠ Left + Subwoofer ≠ White White/black Green Green/black Gray Gray/black Violet Violet/black + Front speaker ≠ Right + Subwoofer ≠ Note: Change the Initial Setting of this Product (refer to the Operation Manual). The subwoofer output of this unit is monaural. Installation Note: • Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly. • Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. • Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. • Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. • The semiconductor laser will be damaged if it overheats, so don't install the unit anywhere hot - for instance, near a heater outlet. • If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 4) 60° Fig. 4 DIN Front/Rear-mount This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods. DIN Front-mount Installation with the rubber bush (Fig. 5) Dashboard 182 Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.) 53 Rubber bush Screw Removing the Unit (Fig. 6) (Fig. 7) Frame Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it.) Fig. 6 Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place.Keeping the keys pressed against the sides of the unit, pull the unit out. Fig. 7 Fig. 3 Fig. 5