Pioneer DEH-P6700MP Owner's Manual - Page 9

Before You Start Section 01 English Removing the front panel 1 Press OPEN to open the front panel. 2 Grip the left side of the front panel and pull it gently outward. Take care not to grip it too tightly or to drop the front panel and protect it from contact with water or other fluids to prevent permanent damage. Attaching the front panel % Replace the front panel by holding it upright to the unit and clipping it securely into the mounting hooks. Important The red lead (ACC) of this unit should be connected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained. Reverse mode If you do not perform an operation within about 30 seconds, screen indications start to reverse, and then continue reversing every 10 seconds. Pressing button 5 when power to this unit is turned off while the ignition switch is set to ACC or ON cancels the reverse mode. Press button 5 again to start the reverse mode. Feature demo The feature demo automatically starts when power to this unit is turned off while the ignition switch is set to ACC or ON. Pressing button 6 during feature demo operation cancels the feature demo mode. Press button 6 again to start the feature mode. Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power. About the demo mode This unit features two demonstration modes. One is the reverse mode, the other is the feature demo mode. ! You cannot cancel a demo mode when the front panel is open. En 9