Pioneer DJM-707 Owner's Manual - Page 11
Rear Panel - dj mixer
View all Pioneer DJM-707 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Rear Panel 43 44 45 PART NAMES AND FUNCTIONS 46 47 57 56 CH-2 R CD R MASTER 2 L PHONO / LINE LR PHONO SEND RETURN LR CH-1 L R L (MONO) MASTER 1 3 COLD 1 GND CD (MONO) PHONO / LINE PHONO BOOTH/ SESSION OUT SIGNAL GND LINE CH-2 PLAYER CONTROL R 2 HOT SIGNAL LINE GND L CH-1 PLAYER CONTROL MIC R L SESSION IN 48 55 54 53 52 51 50 49 43 CH-2 input jacks CD Connect to audio output from CH-2 CD player. PHONO / LINE Connect to audio output from CH-2 analog turntable, cassette deck or other line signal level component. 44 External effector output jacks (SEND) Connect to the input connectors of an external effector. When the top panel switches (MIC SEND, CH-1 SEND, and CH-2 SEND) are set to On, these jacks output the MIC, CH-1, and CH-2 signals to the external effector. When using an effector with a monaural input, connect it to the L channel output only. The signal actually sent to the effector will represent a mix of L and R signals. 45 External effector return jacks (RETURN) Connect to the output connectors of the external effector. When using an effector with monaural output, connect only to the L channel input. The signal received from the effector will be input to both L and R channels. 46 CH-1 input jacks CD Connect to the audio output of the CH-1 CD player. PHONO / LINE Connect to audio output from CH-1 analog turntable, cassette deck or other line signal level component. 47 Microphone input jack (MIC) Connect to a microphone with XLR type or PHONE type plug. 48 Session input jacks (SESSION IN) When using multiple mixers simultaneously, connect the other mixer outputs to these jacks. 49 CH-1 PHONO/LINE selector switch Use to set the input sensitivity at the CH-1 PHONO/LINE connectors. The [PHONO] position supports an MM type cartridge. * When no analog turntable is used, set this switch to the [LINE] side. 50 CH-1 signal ground (SIGNAL GND) Connect to the CH-1 analog turntable's ground wire. Note that this is not meant as a safety ground. 51 CH-1 PLAYER CONTROL jack When a Pioneer DJ CD player is connected to the CH-1 CD jacks, a special control cord can be used to connect this jack to the player's control jack, thus enabling the fader start function. 52 MASTER 1 jacks XLR type balanced output. Connect to the power amplifier's balanced input jacks. 53 CH-2 PLAYER CONTROL jack When a Pioneer DJ CD player is connected to the CH-2 CD jacks, a special control cord used to connect this jack to the player's control jack, thus enabling the fader start function. 54 CH-2 PHONO/LINE selector switch Use to set the input sensitivity at the CH-2 PHONO/LINE connectors. The [PHONO] position supports an MM type cartridge. * When no analog turntable is used, set this switch to the [LINE] side. 55 CH-2 signal ground (SIGNAL GND) Connect to the CH-2 analog turntable's ground wire. Note that this is not meant as a safety ground. 56 BOOTH/SESSION OUT jacks Connector jacks for booth monitor output. When using this unit in tandem with another mixer, connect these jacks to the other mixer's session input jacks. 57 MASTER 2 jacks RCA type unbalanced output. Connect to the power amplifier's unbalanced input jacks. 11