Pioneer DMH-W4600NEX Installation Manual - Page 9
Installation using the, screw holes on the side, of this product
View all Pioneer DMH-W4600NEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
vehicle's location display, and might otherwise cause reduced display performance. • When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents. 5 cm Leave ample space 5 cm • The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifiers to radiate freely. (DMH-WC6600NEX) vehicle or installation location, you may need to adjust the mounting position of the LCD screen in order to prevent impairment of vehicle driving operations. For details on the mounting LCD screen dimensions, refer to The adjusting position and mounting dimension of the display (page 12) before installing. WARNING Do not use a mounting sleeve to install this unit to prevent it from popping out or rattling. 1 Adjust the front-back position of the front panel by removing the flush surface screws on the front edge of the unit ( ) then fix the face panel by using the screw ( ) (optional). Depending on the vehicle, the frontback position of the front panel may need to be adjusted to mount the LCD screen. Slide the face panel to the front before installing the unit to the vehicle. Do not cover this area Installation using the screw holes on the side of this product ▶DMH-WT8600NEX/DMH-WT7600NEX Installation tips The following procedure describes how to install this product with an LCD screen attached to the unit. Depending on the Screw 2 Fasten this product to the factory radio-mounting bracket. Position this product so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at three locations on each side. TIP The amount of this unit's protrusion from the dashboard/console can be adjusted by shifting the position of the screw hole of this unit to the factory radio-mounting bracket. LCD screen mounting bracket Binding head screw (4 mm × 6 mm) TIP The mounting left-center-right position of the LCD screen mounting bracket can be changed depending on the vehicle or installation location of the main unit. Factory radio-mounting bracket If the pawl interferes with installation, you may bend it down out of the way. Dashboard or console Binding head screw (8 mm) or flush surface screw Be sure to use the screws supplied with this product. 3 Fasten the LCD screen mounting bracket to the main unit at the suitable position. 4 Detach the monitor cable cover from the LCD screen ( ), then connect the monitor cable to the LCD screen ( ). After that, attach the LCD screen with adjusting the up-down position ( ) to this unit by using the screws each side ( ). En 9 English