Pioneer DMH-WT76NEX Installation Manual - Page 12

Installing the microphone • Install the microphone in a place where its direction and distance from the driver make it easiest to pick up the driver's voice. • Be sure to turn off (ACC OFF) the product before connecting the microphone. • Depending on the vehicle model, the microphone cable length may be too short when you mount the microphone on the sun visor. In such cases, install the microphone on the steering column. Mounting on the sun visor 1 Fit the microphone lead into the groove. Microphone lead Groove 2 Attach the microphone clip to the sun visor. Microphone clip Clamps Use separately sold clamps to secure the lead where necessary inside the vehicle. Install the microphone on the sun visor when it is in the up position. It cannot recognize the driver's voice if the sun visor is in the down position. Installation on the steering column 1 Detach the microphone base from the microphone clip by sliding the microphone base while pressing the tab. Tab Microphone base 2 Mount the microphone on the steering column. Double-sided tape Clamps Use separately sold clamps to secure the lead where necessary inside the vehicle. NOTE Install the microphone on the steering column, keeping it away from the steering wheel. Adjusting the microphone angle The microphone angle can be adjusted. The adjusting position and mounting dimension of the display ▶DMH-WT8600NEX/DMH- WT7600NEX/DMH-WT76NEX The mounting position of this unit's display can be adjusted (front-back/up-down/ right-left/angle). When mounting the display, adjust the mounting position and dimensions so that your view is clear and it does not impair your driving. WARNING Make sure that none of the following conditions exist when mounting the display. Otherwise, an accident may occur. • It impairs the operation of the steering wheel and levers (shift lever, windshield wiper switch, turn signal switch, etc.). • It impairs the operation of the airbags. • It significantly impairs the operation of the hazard switch. • It impairs the ability to identify or operate other control switches. • You are unable to see gauges, meters or warning indicators. • It interferes with in-vehicle devices (switches, panel, glove compartment, cup holder, etc.). Depending on the vehicle, the display may hinder access to the glove compartment or cup holder, or it may block the air conditioner vents. 12 En