Pioneer DRM-7000 User Manual for the DVD-7361 drive - Page 8

A HARDWARE TOUR TOP VIEW 0 0 Function switch ON OFF This switch is used to check the device before shipment, and its setting should never be changed. RPC (Region Play Control) Set switch ON = Stay in RPC Phase I mode OFF = Start RPC Phase II mode (Never return to Phase I mode after Phase II mode is used) ¶ Set ON at the time of shipping from the plant. ¶ For a DVD Video playback system (computer) for Phase I, please use with Phase I. When the DVD Video playback system (computer) and the drive have different region codes, DVD Video playback is not possible. Set the jumper switch to OFF only when use of a drive corresponding to Phase II has been specified clearly for the DVD Video playback system (computer). The drive will be initialized automatically and will operate in Phase II mode. TO INSTALL THE DRIVE For instructions on how to open the access doors, see the operating instructions for the DRM-7000 disc changer. Before installation, be sure to specify the following settings at the rear of each drive to be installed. ¶ SCSI ID assignment Specify the SCSI IDs to be used so as to ensure that the same SCSI ID is not assigned by more than one drive on the same SCSI bus. ¶ Termination Set the termination switch of the last drive in the SCSI chain to the ON position. 8 En Warning about static electricity Always be sure never to touch the contacts or ports when operating drives. Also be sure to touch a metallic surface on the changer before installing additional drives to the changer.