Pioneer DRM-7000 User Manual for the Magazine AF751 - Page 5
To Install The Disc Magazine
View all Pioneer DRM-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
English TO INSTALL THE DISC MAGAZINE For instructions on how to open the access doors, see the operating instructions for the DRM-7000 disc changer. 1. Insert discs into a disc magazine. 1 Turn the release knob to the vertical direction to unlock. 2 Insert discs. 3 Turn the release knob to the horizontal direction to lock the discs into place. 2. Insert magazine into changer. Holding the handle of the disc magazine, insert the disc magazine into the changer following the changer guide rails until it runs against the stopper. And turn the handle to the left with pushing the magazine in so that the lock pin on the left of the magazine slides into the corresponding hole along the side of the changer. Lock pin Hole Guide rails Release knob Lock release Lock ≠ Label NOTES: ¶ Insert with label facing upward. ¶ Insert discs horizontally. Otherwise it may result in damage to the discs. ¶ Take care not to scratch or do other damage to the recording faces of discs. ¶ Do not turn a disc magazine upside down while the lock is disengaged. Otherwise it may result in discs falling out of the magazine. ¶ Discs may not be inserted or removed when the magazine is locked, and the use of excessive force when trying to do so may result in damage to discs or to the disc magazine. Handle Shown above is the insertion to the front magazine bay. Though the insertion to the rear magazine bay is almost same but note that the proper installation position is in the place where it is very secluded. To remove a disc magazine from the changer, pull the handle towards you and pull the magazine from the changer. 5 En