Pioneer DVR-510H-S Owner's Manual - Page 8

Before you start, What's in the box, Putting the batteries in the remote, control, Using the remote - remote control

Get Pioneer DVR-510H-S PDF manuals and user guides View all Pioneer DVR-510H-S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

01 Before you start What's in the box Thank you for buying this Pioneer product. Please confirm that the following accessories are in the box when you open it. • Remote control • AA/R6P dry cell batteries x2 • Audio/video cable (red/white/yellow) • RF antenna cable • Power cable • These operating instructions • Warranty card Putting the batteries in the remote control 1 Open the battery compartment cover on the back of the remote control. 2 Insert two AA/R6P batteries into the battery compartment following the indications ( , ) inside the compartment. 3 Close the cover. Note Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following: • Don't mix new and old batteries together. • Don't use different kinds of battery together- although they may look similar, different batteries may have different voltages. • Make sure that the plus and minus ends of each battery match the indications in the battery compartment. • Remove batteries from equipment that isn't going to be used for a month or more. • When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. Using the remote control Keep in mind the following when using the remote control: • Make sure that there are no obstacles between the remote and the remote sensor on the unit. • Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit's remote sensor. • Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit. • Replace the batteries when you notice a fall off in the operating range of the remote. • When the batteries run down or you change the batteries, the remote control mode and TV preset codes are automatically reset. See Remote Control Set on page 90 and Setting up the remote to control your TV on page 101 to reset them. • Use within the operating range and angle, as shown. 30 30 23ft • You can control this recorder using the remote sensor of another Pioneer component using the CONTROL IN jack on the rear panel. See Rear panel connections on page 12 for more information. 8 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
Before you start
01
8
En
What’s in the box
Thank you for buying this Pioneer product. Please
confirm that the following accessories are in the box
when you open it.
•
Remote control
•
AA/R6P dry cell batteries x2
•
Audio/video cable (red/white/yellow)
•
RF antenna cable
•
Power cable
•
These operating instructions
•
Warranty card
Putting the batteries in the remote
control
1
Open the battery compartment cover on the
back of the remote control.
2
Insert two AA/R6P batteries into the battery
compartment following the indications (
±
,
²
) inside
the compartment.
3
Close the cover.
Note
Incorrect use of batteries can result in hazards such as
leakage and bursting. Please observe the following:
•
Don’t mix new and old batteries together.
•
Don’t use different kinds of battery together—
although they may look similar, different batteries
may have different voltages.
•
Make sure that the plus and minus ends of each
battery match the indications in the battery
compartment.
•
Remove batteries from equipment that isn’t going to
be used for a month or more.
•
When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction’s rules that apply in your country or
area.
Using the remote control
Keep in mind the following when using the remote
control:
•
Make sure that there are no obstacles between the
remote and the remote sensor on the unit.
•
Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the unit’s
remote sensor.
•
Remote controllers for different devices can interfere
with each other. Avoid using remotes for other
equipment located close to this unit.
•
Replace the batteries when you notice a fall off in the
operating range of the remote.
•
When the batteries run down or you change the
batteries, the remote control mode and TV preset
codes are automatically reset. See
Remote Control
Set
on page 90 and
Setting up the remote to control
your TV
on page 101 to reset them.
•
Use within the operating range and angle, as shown.
•
You can control this recorder using the remote
sensor of another Pioneer component using the
CONTROL IN
jack on the rear panel. See
Rear panel
connections
on page 12 for more information.
30
30
23ft