Pioneer GEX-P10XMT Other Manual - Page 4

Installation Installing the Antenna Unit Installation using the magnet of antenna 6in. (15.5 cm) clamper 6in. (15.5 cm) Note: • If the antenna is mounted on the vehicle's roof, it can be installed in positions other than those in the diagram. To ensure the best reception, mount more than six inches away from the edge of the roof. • If mounted in an exterior location on the vehicle other than the vehicle's roof, reception may be poor. • Do not install inside the vehicle, as reception will be extremely poor. Secure the antenna cable Secure the antenna cable with the supplied clamper around here. Route the antenna cable When routing the lead inside the trunk Clamps Use clamps to secure the lead where necessary inside the vehicle. Rubber packing When routing the lead through the top of the door Waterproof pad Make sure the waterproof pad contacts the top of the rubber packing. Make a U-shaped loop in the lead outside the rubber packing to prevent rainwater from flowing along the lead into the interior of the vehicle. Make a U-shaped loop in the lead on the outside to prevent rainwater from flowing along the lead into the interior of the vehicle. Clamps Use clamps to secure the lead where necessary inside the vehicle. Note: • Secure the antenna cable with the supplied clamper where required.