Pioneer GEX-P920XM Other Manual - Page 3

Installation Note: • Before making a final installation of the unit, tem- porarily connect the wiring to confirm that the connections are correct and the system works properly. • Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. • Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. • Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. • When mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings. • Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it. • Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts. • If this unit is installed in the passenger compartment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident. • If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit. • When installing this unit, do not stack it with other products (e.g. do not stack with the hide-away TV tuner) as there is the possibility of the XM tuner interferring with the other unit, and causing poor reception. • Install the antenna on as flat a place as possible. • Do not paint the antenna, as this may affect its per- formance. • Do not place items such as magnetic cards close to the antenna because it has a powerful field of magnetism. • The antenna may be less sensitive when it is snowing. • When installing the antenna with magnet, be careful not to scratch the vehicle body. • Be sure to detach the antenna and place inside the vehicle every time you enter a carwash. If it is left on the outside it may be knocked off and scratch the vehicle body. A Title (English) Installing the Unit Mounting with Brackets Tapping screw (4 × 12 mm) Car mat or chassis Screw (4 × 6 mm) Bracket Drill 2 - 2.5 mm diameter holes.