Pioneer GM-A5602 Owner's Manual - Page 8

Section 03 Connecting the units ! Install and route the separately sold battery wire as far as possible from the speaker wires. Install and route the separately sold battery wire, ground wire, speaker wires and the amplifier as far away as possible from the antenna, antenna cable and tuner. About bridged mode to 8 W for stereo connection, or 4 W to 8 W for monaural and other bridge connection. Subwoofer Speaker channel Two-channel output One-channel output Power Nominal input: Min. 150 W (GM-A5602) Min. 60 W (GM-A3602) Nominal input: Min. 450 W (GM-A5602) Min. 180 W (GM-A3602) ! Do not install or use this amplifier by wiring speakers rated at 4 W (or lower) in parallel to achieve a 2 W (or lower) bridged mode (Diagram B). Amplifier damage, smoke, and overheating could result from improper bridging. The amplifier surface could also become hot to the touch and minor burns could result. To properly install or use a bridged mode and achieve a 4 W load, wire two 8 W speakers in parallel with Left + and Right * (Diagram A) or use a single 4 W speaker. In addition, refer to the speaker instruction manual for information on the correct connection procedure. ! For any further enquiries, contact your local authorized Pioneer dealer or customer service. Other than subwoofer Speaker channel Two-channel output One-channel output Power MAX input: Min. 300 W (GM-A5602) Min. 120 W (GM-A3602) MAX input: Min. 900 W (GM-A5602) Min. 400 W (GM-A3602) Connecting the speakers The speaker output mode can be two-channel (stereo) or one-channel (mono). Connect the speaker leads to suit the mode according to the figures shown below. Two-channel output (Stereo) 1 About suitable specification of speaker 2 Ensure speakers conform to the following standards, otherwise there is a risk of fire, smoke or damage. Speaker impedance is 2 W 1 Speaker (Left) 2 Speaker (Right) 8 En