Pioneer HTP-076 Instruction Manual English - Page 74
Distance, Setting Item, Default Value, Setting Details
View all Pioneer HTP-076 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ Setting Item Surround Crossover Double Bass Default Value Small 150Hz On Setting Details Set the low range capabilities for each channel by setting either small or large. "Small": For small speakers whose low range capabilities may be limited "Large": For full-range speakers with sufficient low range capabilities • When "Front" is set to "Small", this is set to "Small". • If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. When there are speakers that have been set to "Small", set the Hz under which you would like other speakers to play bass, and also set Hz under which you would like the LFE (low frequency effect) to play the bass. The value from "50Hz" to "200Hz" can be set. This can be selected only when "Configuration" - "Subwoofer" is set to "Yes" and "Front" is set to "Large". Boost bass output by feeding bass sounds from the front left and right, and center speakers to the subwoofer. "On": Bass output will be boosted "Off": Bass output will not be boosted 3. Distance Set the distance from each speaker to the listening position. Setting Item Front Left Center Front Right Height Left Height Right Surround Right Surround Left Subwoofer Default Value 10.0 ft/3.00 m 10.0 ft/3.00 m 10.0 ft/3.00 m 10.0 ft/3.00 m 10.0 ft/3.00 m 10.0 ft/3.00 m 10.0 ft/3.00 m 10.0 ft/3.00 m Setting Details Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. • Default values vary depending on the regions. • The unit of distance can be changed by pressing the MODE button on the remote controller. When using the unit "feet", the setting is available in increments of 0.1 ft from 0.1 ft to 30.0 ft. When using the unit "meter", the setting is available in increments of 0.03 m from 0.03 m to 9.00 m. 74 Front Panel≫ Rear Panel≫ Remote≫