Pioneer MVH-P8200 Owner's Manual - Page 33

Operating this unit Section 03 English This function is available only for MVH-P8200BT. Bluetooth telephone data can be deleted. To protect personal information, we recommend deleting this data before transferring the unit to other persons. The following settings will be deleted. ! phone book entries on the Bluetooth telephone ! preset numbers on the Bluetooth telephone ! registration assignment of the Bluetooth tele- phone ! call history of the Bluetooth telephone ! information of the connected Bluetooth telephone ! PIN code 1 Press M.C. to display the setting mode. 2 Use M.C. to select Yes. Turn to change the mode. Press to select. Cleared is displayed and the settings are deleted. To cancel, select No. ! While this function is in use, do not turn off the engine. BT Ver. Info. (Bluetooth version display) This function is available only for MVH-P8200BT. 1 Press M.C. to display the Bluetooth (microproces- sor) version of this unit. Software Update (updating the software) This function is available only for MVH-P8200BT. This function is used to update this unit with the latest software. For information on the software and updating, refer to our website. 1 Press M.C. to display the setting mode. 2 Use M.C. to select Yes to show a confirmation dis- play. Turn to change the mode. Press to select. To cancel, select No. Follow the on-screen instructions to finish updating the software. Auto EQ (auto-equalizing) The auto-equalizer automatically measures the car's interior acoustic characteristics, and then creates an auto-equalizer curve based on that information. ! To perform this function, dedicated micro- phone (e.g. CD-MC20) is required. WARNING As a loud tone (noise) may be emitted from the speakers when measuring the car's interior acoustic characteristics, never perform auto EQ while driving. CAUTION ! Thoroughly check the conditions before per- forming auto EQ as the speakers may be damaged if these functions are performed when: - The speakers are incorrectly connected. (For example, when a rear speaker is connected as a subwoofer output.) - A speaker is connected to a power amp delivering output higher than the speaker's maximum input power capability. ! If the microphone is placed in an unsuitable position the measurement tone may become loud and measurement may take a long time, resulting in battery drainage. Be sure to place the microphone in the specified location. Before operating the auto EQ function ! Carry out auto EQ in as quiet a place as possible, with the car engine and air conditioning switched off. Also cut power to car phones or portable telephones in the car, or remove them from the car before carrying out auto EQ. Sounds other than the measurement tone (surrounding sounds, engine sound, telephones ringing etc.) may prevent correct measurement of the car interior acoustic characteristics. ! Be sure to carry out auto EQ using the optional microphone. Using another microphone may prevent measurement, or result in incorrect measurement of the car interior acoustic characteristics. ! In order to perform auto EQ, the front speaker must be connected. ! When this unit is connected to a power amp with input level control, auto EQ may not be possible if the power amp's input level is set below the standard level. ! When this unit is connected to a power amp with an LPF, turn this LPF off before performing auto EQ. Also set the cut-off frequency for the built-in LPF of an active subwoofer to the highest frequency. En 33