Pioneer PD-M406 Operating Instructions - Page 4

CONTENTS CONFIRM SUPPLIED ACCESSORIES 4 PUT BATTERIES INTO THE REMOTE CONTROL UNIT 4 CAUTIONS REGARDING HANDLING 5 BEFORE OPERATING THE PLAYER 6 CONNECTIONS 7 NAMES AND FUNCTIONS OF PARTS 8 BASIC OPERATION 9 VARIOUS OPERATIONS 10 TO PLAY ONLY DESIRED TRACKS/DISCS 12 TROUBLESHOOTING 15 SPECIFICATIONS Back cover CONFlRMSUPPUEDACCESSORIES 0 0 0 0 &Compact Disc Magazine x 1 (Called Gdisc magazine in the explanatory text 1 NO7-E: The supplied 6-disc magazine is for 72 cm ( 5inch) disc only @ Output cable x 1 0 Control cable x 1 (except for PD-M426 of Australian and New Zealand models) 0 Remote control unit x 1 (PD-M426 only) @ &IA/R03 dry cell batteries x 2 (PD-M426 only) PUTBATTERIESINTOTHEREMOTE CONTROLUNIT (PD-M426only) Open the lid of the battery compartment on the rear of the remote control unit, and insert the batteries ( size 'AAA' (IEC R03)). taking care to align the @ and 0 polarities correctly NOTES: l In order to prevent battery leakage, remove the batteries when nor using the remore control unir for an extended period lone month or morel If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries with new ones l Do nor allow books or other objects ro resr on rop of the remote control unit, since the buttons may be depressed, causing faster exhaustion of the batteries Incorrect use of batteries may cause leakage or rupture Always be sure to follow these guidelines: A Always insert batteries into the battery compartment correctly matching the positive @ and negative Qpolarities, as shown by the display inside the compartment 6 Never mix new and used batteries C Batteries of the same size may have different voltages, depending on brand Do not mix different brands of batteries 1 REMOTECONTROLOPERATIONS 1 1 (PD-M426only) When operating the remote control unit, point the unit's infrared signal transmitter at the remote control receiver (REMOTE SENSOR) on the front panel of the player The remote control unit can be used within a range of about 7 meters (23 feet) from the remote sensor, and within angles of up to about 30 degrees , POWER-CORD CAUTION Handle the power cord by the plug Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock Do not place the unit, a piece of furniture, etc , on the power cord, or pinch the cord Never make a knot in the cord or tie it with other cords The power cords should be routed such that they are not likely to be stepped on A damaged power cord can cause fire or give you an electrical shock Check the power cord once in a while When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement 4 NOTE: If the remote control sensor window is in a position where it receives strong light such as sunlight or fluorescent light, control may nor be possible NOTE for PD-M466: Operate the PD-M406 using the remote control unit which accompanies the amplifier (See page 7 I