Pioneer PDP5030HD Owner's Manual - Page 42

Using external equipment Viewing an image from a computer Connecting a computer Use the PC terminals to connect a computer. A • The PC input terminals are DDC1/2B-compatible. • Refer to page 65 for a list of computer signals compatible with the Plasma Display System. Media Receiver (front view) STANDBY/ON POWER MEDIA RECEIVER PDP-R03U RGB cable (commercially available) ø 3.5 mm stereo minijack cable (commercially available) Computer Signal names for 15-pin mini D-sub connecter 543 21 10 9 8 7 6 15 14 13 12 11 Pin No. 1 2 3 4 5 Signal name R G B Not connected CSYNC Pin No. 6 7 8 9 0 Signal name GND (Ground) GND (Ground) GND (Ground) ‫ם‬5V GND (Ground) A • Macintosh adaptor may be required for use for some Macintosh computers. Pin No. q w e r t Signal name Not connected SDA HD VD SCL TV CBL VCR DVD TV /SAT /LD /DTV ANT INPUT FRONT AV SURR MTS CC SELECTION SPLIT SELECT ‫؀‬ SCREEN MODE FREEZE SUB SUB CH INPUT ‫؁‬ DISPLAY SLEEP EDIT/ LEARN 123 456 789 0 CH ENTER INPUT SOURCE TV INPUT1 INPUT2 INPUT3 INPUT4 PC Displaying an image from a computer When connecting to a computer, the correct input signal type is automatically detected. If the computer image does not come in clearly, you may need to set the Auto Sync. adjustment on the "Auto Sync." in the menu. (See page 42.) You only need to select the input source on the "INPUT SOURCE" menu. To view an image from a computer, select "PC" from the "INPUT SOURCE" menu using INPUT on the remote control unit or on the Plasma Display. (See page 43.) A • Each time INPUT is pressed, the input source toggles. • PC INPUT terminals cannot be used for audiovisual equipment. Use the INPUT 3 (RGB) terminal on the rear of the Media Receiver when connecting audiovisual equipment with an RGB signal.(See page 37.) E-39