Pioneer PRO150FD Owner's Manual - Page 18
blocking shield, apply it with the double - pro plasma
UPC - 012562864990
View all Pioneer PRO150FD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
05 Preparation Attaching the light-blocking shield (PRO-150FD only) This part prevents reflection of the cables connected to the back of the plasma display on the base cover. Note • Attach it after anchoring the base cover on a flat stable place. Light-blocking shield 2 While firmly holding the ends of the lightblocking shield, apply it with the doublesided adhesive tape. Front Front Base cover Rear Rear 1 Remove the double-sided adhesive tape from the light-blocking shield. Remove each double-sided adhesive tape. Note • Be careful that the light-blocking shield does not catch on the pipe insertion holes. • Anchor it in place so that there are no gaps (See diagram at below). If there is a gap, the light-blocking shield may peel off. 3 Anchor it in place while pressing it down from above. Front Rear Press Press Be sure that there is no gap. 18 En