Pioneer S-2EX Owner's Manual - Page 5

English Attaching and removing the front grille The front grille of this speaker system is removable. Follow the instructions below to attach/remove the grilles. Attaching the grille 1 Insert the supplied fastening screws into the four holes provided on the front of the speaker. Use your fingers (not a screwdriver) to secure the screws to the front of the speaker. Removing the grille 1 Loosen, then remove the finishing screws from the four corners on the front of the grille. 2 After detaching the grille, remove the fastening screws from the four holes on the front of the speaker. Long fastening screws Optionally, you can insert the supplied caps into the holes. Short fastening screws 2 Line up the holes on the grille with the protruding ends of the screws on the front of the speaker and press firmly. 3 Insert the supplied finishing screws into the four holes on the front of the grille and tighten to secure. Use your fingers to tighten the finishing screws. Finishing screws • Do not use a screwdriver (or hex wrench) to tighten the screws. Overtightening could damage the speaker. • When not in use, store the screws with these operating instructions for safekeeping. Magnetic shielding This speaker system is magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker system is installed extremely close to the screen of a television set. If this happens, turn off the television, then turn it on again after 15 min to 30 min. If the problem persists, place the speaker system away from the television set. Cleaning the speaker cabinet With normal use, wiping with a dry cloth should be sufficient to keep the cabinet clean. If necessary, clean with a cloth dipped in a neutral cleanser diluted five or six times with water, and wrung out well. Do not use furniture wax or cleansers. Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit since these will corrode the surfaces. 5 En