Pioneer S-A4SPT-PM Operating Instructions - Page 4

2 Loosen the terminal screw cover, insert the wire core into the hole and retighten the cover. Wire with white line Connect to amplifier's positive speaker output terminal. Wire without white line Connect to amplifier's negative speaker output terminal. • After connecting the terminals, lightly tug on the end of the cable to confirm that the connections are tight. Loose connections may result in distorted or interrupted sound. • Do not allow wire cores to protrude from the terminals and touch each other. Allowing the positive and negative wires to touch may result in overloading of the speaker circuits, causing the speakers to be damaged or stop operating. • When the speaker systems are connected to the amplifier, if one of the speaker systems' terminals is connected in reverse (positive to negative terminals), stereo phase will be reversed, preventing proper stereo effect from being produced. CAUTION These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts. D3-4-2-2-3_A_En Cleaning the speaker cabinet With normal use, wiping with a dry cloth should be sufficient to keep the cabinet clean. If necessary, clean with a cloth dipped in a neutral cleanser diluted five or six times with water, and wrung out well. Do not use furniture wax or cleansers. Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit since these will corrode the surfaces. Frequency response and harmonic distortion Frequency response/Harmonic distortion 110 0˚ 90 22.5˚ Output level (dB) 70 50 2nd harmonic 45˚ 3rd harmonic 30 0 10 100 1 k 10 k 100 kHz Magnetic shielding This speaker system is magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker system is installed extremely close to the screen of a television set. If this happens, turn off the television, then turn it on again after 15 min to 30 min. If the problem persists, place the speaker system away from the television set. Specifications Enclosure Bass-reflex bookshelf type (magnetically shielded) Configuration 2-way Woofer 10 cm (4 inch) cone Mid-range/tweeter 2 cm (3/4 inch) dome Nominal impedance 6 Ω Frequency response 50 Hz to 40 000 Hz Sensitivity 84 dB Maximum input power 100 W Crossover frequency 3.5 kHz Exterior dimensions 154 (W) mm x 246 (H) mm x 213 (D) mm 6 1/16 (W) in. x 9 11/16 (H) in. x 8 3/8 (D) in. Weight 3.7 kg (8.2 lbs.) Supplied accessories Speaker cable (2.5 m) × 1 Non skid pads × 1 set Operating Instructions • Specifications and design subject to possible modification without notice, due to improvements. For Europe If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. 4 En