Pioneer S-IW651-LR Owner's Manual - Page 6

13 Adjust the angle of the tweeter. (S-IW631-LR/S-IW831-LR only) Gently press the edge of the tweeter flange to adjust the angle of the tweeter as desired. Be careful not to touch the diaphragm while doing this. Make sure not to touch the diaphragm as it can be easily damaged. • Once you have pushed it in, make sure you press it firmly against the speaker so that the grille doesn't fall off and cause an accident. • To remove the grille, use the supplied tool to hook into the holes located near the corners and pull the grille out. When doing this, make sure to pull all four corners out evenly. Forcing the grille out from one corner alone will cause the grille to be deformed. 14 Adjust the settings of the treble and/or bass controls as necessary. • Treble adjustment (all models) The standard setting is 0. The treble switch located in the front of the speaker has three positions to choose from, +/0/-. • Bass adjustment (S-IW651-LR/S-IW851-LR only) The standard setting is 0. The bass switch located in the front of the speaker has two positions to choose from, 0/-. 15 Attach the butyl rubber tapes on the inside of the grille. Attach the eight butyl rubber tapes to each grille, lining up the butyl rubber tapes to the marks on the inside of the grille. Then peel off the protective paper. Connections Connecting to an amplifier Make sure you have read the connection instructions in the manual supplied with the amplifier and that all equipment is turned off before making any connections. • When using a set of speakers connected to an amplifier, you won't be able to obtain the correct stereo effect if the polarity (+, -) of one of the speakers (left or right) is reversed. Additional Information 16 Attach the grille to the speaker. The grille is designed with a specific mounting orientation. Gently push the grille onto the speaker, lining up the corners of the grille to the grooves in the speaker. Then line up the entire grille to the grooves in the speaker and attach the grille by pressing in on the edges. Orientate the grille so that the edge marked in blue is located at the top of the speaker. Cleaning the speaker Use a dust brush to wipe off dust and dirt. Never use furniture wax, cleaners, thinners, benzine, insecticide sprays or other chemicals on or near the speakers, since these will corrode the surfaces. Make sure to press on the edges. Pressing on the middle of the grille will cause it to be deformed. 6 En