Pioneer S606 Operating Instructions - Page 10

INTERFACE FRONT VIEW BUSY 1 23 45 6 1 Forced Ejection Hole Insert a stiff rod into the hole and push to eject the tray when the tray doesn't unload by pressing the Eject button. In the normal operation, the eject button should be used to unload the tray. Make sure the power of the drive is turned off and wait more than one minute till the disc rotation is stopped when access the eject hole. 2 BUSY Indicator Operation status is indicated as follows. During reading Lights During writing Lights 3 Ventilation Hole Do not block this part. 4 Eject Button (0) To unload /load the disc, press the button. 5 Disc Tray Open the loading tray by pressing the eject button, then place a CD or DVD disc into the slit with the label facing up. Press the eject button or push the front part of tray to load the tray with the disc. Do not attempt to pull out the disc tray forcibly. 6 Power Indicator Lights when the unit is on. Precautions on playing 8 cm (3.15") Discs An 8 cm (3.15") disc cannot be played even an adapter is attached to the disc when the drive is upright condition. ABOUT REGION CODES The region code can be changed ONLY 5 times, including the 1st setting. Please be aware the 5th change will be PERMANENT, therefore, please pay attention when changing region codes. ÷ Region codes are part of the DVD Standard. However, Region codes on DVD discs are optional. DVD discs with no specified Region code can be played on all players. 10 En