Pioneer SP-BS22-LR Owners Manual - Page 2
Connecting Your System, Installing The Base To The Sp-fs52, Floorstanding Speakers, Installing - loudspeaker
View all Pioneer SP-BS22-LR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
ENGLISH www.pioneerelectronics.com CONNECTING YOUR SYSTEM IMPORTANT: Make sure all equipment is turned off before making any connections. Correct wiring of your loudspeakers is essential for achieving the best sound quality. Be careful to ensure proper polarity of connection. We recommend a minimum of 18 gauge for runs up to 25 feet, and thicker for longer runs. Most loudspeaker cable is coded to ease this task. Typically the ribbed or striped side is connected to the positive (red) terminal. Make sure that the amplifier positive (red) terminal is connected to the loudspeaker positive (red) terminal. Strip off ½" of insulation from the ends of the cable, twist the bare strands and insert into the binding posts. Take care that no stray strands of wire short across between the terminals. Negative Positive 1: Strip the cover and twist the strands Wire going to negative terminal of receiver Wire going to positive terminal of receiver 2: Connect each speaker cable (not included) to one set of the receiver's speaker output terminals and the speaker input terminals. The red terminal is the positive (+), and the black terminal is the negative (-). Make sure that the receiver positive (Nreédga)ttieverminal is connecPtoesdititvoe the speaker positive (red) terminal. INSTALLING AND REMOVINFpGiol sailtliTavneHtdvueErrsélcGaepbRtoerunIreLL The front the lower peadngFneiéel glaaloglatifnvreittlhlvdeumersréaglacyrebipolbltrenneuereraermthoevemdoifudnteinsgirepdo.iTnotsrewmithovbeo,thhold hands and pull forward gently, away from the speaker. Repeat as you work your way up the grill. To replace the grill on the speaker, align the pegs on the grill with the holes in the speaker and press in slowly. Negativo Positivo INSTALLING THE BASE TO ATlaHmbEre qSuePv-aFalSter5m2inal FLOORSATlaAmbNreDquIeNvaGal tSermPinEalAKERpoSsitivo del receptor Included innethgaetivSoPde-lFreSc5ep2tocr arton are (1) base and (4) screws. Attach the base to the bottom of the speaker using (4) screws, as illustrated. (Screwdriver is not included.) Supporting Hooks (Not Included) Sufficiently thick cord (Not Included) Safety catch SECURING THE SP-FS52 FLOORSTANDING SPEAKERS The SP-FS52 speaker comes with a safety catch pre-installed on the back of the cabinet for securing to a wall to avoid tipping. Screw a supporting hook (not included) into the wall behind the speaker. Pass a thick cord (not included) around the supporting hook and through the safety catch so that the speaker is stabilized (make sure to test that it supports the weight of the speaker). After installing, make sure the speaker is securely fixed. CAUTION: The safety catch is not a mounting fixture and the speaker should not be hung directly from the wall using this catch. Always use a cord when stabilizing the speaker. Pioneer disclaims all responsibility for any losses or damage resulting from improper assembly, installation, insufficient strength of the installation materials, misuse, or natural disasters. When placing this unit, ensure that it is firmly secured and avoid areas where it may be likely to fall and cause injury in the event of a natural disaster (such as an earthquake). Do not stand on the speaker stand base to push or swing the speaker. The speaker may fall and break, or someone may be injured. Play close attention to children around the speaker. 2