Pioneer SVM 1000 SVM-1000 Operating Instructions - Page 34

THE VIDEO EQUALIZER FUNCTION THE VIDEO EQUALIZER FUNCTION Rotating the channel equalizer dial normally applies equalizer effects on audio only. However, by using the VIDEO EQ function, effects can be applied to video as well. VIDEO EQ HI 10 10 9 9 8 8 7 7 6 6 5 5 4 4 3 3 2 2 1 1 0 0 SET UP THE VIDEO EQ 1 Hold down the VIDEO EQ button. This initiates the equalizer setup mode. 2 Touch each applicable button. Touch each applicable button on the screen to operate the VIDEO EQ setup. • Whenever power is first turned on, default settings are as follows: HI: CONTRAST MID: HUE LOW: SATURATION Whenever power is turned OFF, the unit returns to the above status. • Identical parameter values cannot be allocated to HI, MID and LOW. VIDEO EQ SET UP Use to make the video effects change simultaneously when using the equalizer. OFF: Disables the VIDEO EQ. R: Used when assigning parameters that change the red elements of the VIDEO EQ. Used when assigning parameters. G: Used when assigning parameters that change the green elements of the VIDEO EQ. Used when assigning parameters. B: Used when assigning parameters that change the blue elements of the VIDEO EQ. CONTRAST: Used when assigning parameters that change the contrast of the VIDEO EQ. HUE: Used when assigning parameters that change the hue of the VIDEO EQ. SATURATION: Used when assigning parameters that change the saturation of the VIDEO EQ. 3 Touch [EXIT]. This ends the equalizer setup mode. TURNING THE EQUALIZER ON/OFF 1 Press the VIDEO EQ button. The VIDEO EQ settings will alternate between enabled/ disabled each time the button is pressed. 34 En