Pioneer SX-205 Service Manual - Page 24

SX-305RDS, SX-205RDS 0 SPEAKERS (I OFF, - ON) buttons These are used to select the speaker through which you wish to listen. A : When the speakers connected to the A terminals are in use. B : When the speakers connected to the B terminals are in use. • Turn both A and B speakers to the OFF position when only headphones are in use. ® CHARACTER/SEARCH button When receiving an AM broadcast, or when in the FM RT, FM PS modes: Press the button, INPUT" is displayed, and the mode switches to manual station name input. When in the FM PTY mode: Press the button, "SEARCH" is displayed, and the mode switches to program type search. • This button does not function when the frequency is displayed (FM broadcast only). C) RF ATT button Set this button to ON when receiving strong FM signals (near-by stations) to reduce sound distortion. (RF ATT indicator lights.) Normally, this button should be set to OFF. This button has no effect on reception of AM broadcasts. 6 MEMORY button Pressing this button will result in the memorization of the current broadcast band, reception frequency, RF ATT (FM reception only) and FM AUTO/MONO mode. This button is also used to select characters during station name entry and to clear memory during ERASE PI operation. It EON (Enhanced Other network information) MODE button/ indicator Remote sensor Operation display panel (a) DIRECT ON/OFF indicator (b) LOUDNESS indicator (c) TAPE 2 monitor indicator. (d) CLASS indicator (e) MONO indicator (f) Lights up when a stereo FM broadcast is being received. (g) Lights up when a station is tuned. (h) RF ATT indicator (i) Lights when an RDS broadcast is received. (j) Lights when a station bloadcasting EON information is received. (k) Frequency, function, character display (I) MEMORY indicator (m) Channel display 10 (10 (c) (di lei if) (7) ZS]LIMa .3/ (71111) LECE2T3MLi; ItYIBI r (h) ::PPET.AIMMETP1113.t1:1, -(1) (k) (ml gCLASS button Use to switch between preset memory classes 1to 3. In each class, one station can be memorized in each of the 1 to 10 STATION CALL buttons, enabling a total of 30 stations to be memorized. ® FM/AM selector button This button is used to select either AM or FM reception. TUNING buttons (-, +) Use for tuning frequencies. Press the buttons to change the frequency display (3-speed Accel Tuning) (see page 28). In the Manual Name input mode and PTY search mode, use to select characters and program types. © STATION buttons (-, +) +: Stations change in order in the upward direction. -: Stations change in order in the downward direction. BASS tone control Use to adjust low-frequency tones. The center position is the flat (normal) position. When turned to the right, low-frequency tones are emphasized. NOTE: This control can not be used when the DIRECT function is ON. The DIRECT function can be turned ON/OFF using the remote control unit. 6 TREBLE tone control Use to adjust high-frequency tones. The center position is the flat (normal) position. When turned to the right, high-frequency tones are emphasized. NOTE: This control can not be used when the DIRECT function is ON. The DIRECT function can be turned ON/OFF using the remote control unit. rl BALANCE control Should normally be left in the center position. Adjust balance if the sound is louder from one of the speakers. If the right side is louder, turn toward the L position and if the left side is louder, turn toward the R position. NOTE: This control can not be used when the DIRECT function is ON. The DIRECT function can be turned ON/OFF using the remote control unit. 36