Pioneer VSX-834 AV Receiver Instruction Manual English - Page 77
Mcacc
View all Pioneer VSX-834 AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ 5. Dolby Enabled Speaker Change the settings of Dolby Enabled Speakers. Setting Item Default Value Dolby Enabled 6.0 ft/1.80 m Speaker to Ceiling Reflex Optimizer Off Setting Details Set the distance between the Dolby Enabled Speaker and the ceiling. Select between "0.1 ft/0.03 m" and "15.0 ft/4.50 m" (0.1 ft/0.03 m units). • The unit of distance (ft/m) is displayed using the unit selected for the "Distance" setting. You can enhance the reflection effect of Dolby Enabled Speakers from the ceiling. "Off": When this function is not used "On": When this function is used • The function is not effective if the listening mode is Pure Direct. • This setting can be selected when "Configuration" - "Height Speaker" is set to "Dolby Speaker". 6. Speaker Virtualizer The Speaker Virtualizer function can be switched between On and Off. Setting Item Speaker Virtualizer Default Value On Setting Details When this is set to "On", a virtual speaker can be set. "On": When this function is used "Off": When this function is not used • When this is set to "Off", some of the listening modes cannot be selected. ( p58) 3. MCACC 1. Full Auto MCACC Place the supplied speaker setup microphone in the listening position, measure the test tones emitted by the speakers, then the unit automatically sets the optimum volume level for each speaker, the crossover frequencies, and the distance from the listening position. This also automatically adjusts the equalizers for the speakers and enables correction of distortion caused by the acoustic environment of the room. • Calibration takes between 3 and 12 minutes to be completed. The speakers emit the test tone at high volume during measurement, so be careful of your surroundings. Keep the room as quiet as possible during measurement. • If you have connected a subwoofer, check the power and volume of the subwoofer. Set the subwoofer volume to more than halfway. • If the power of this unit suddenly turns off, the wires in the speaker cables may have touch the rear panel or other wires and tripped the protection circuit. Twist the wires again properly and make sure they do not stick out of the speaker terminals when connecting. 1. Select the connected speaker configuration. Full Auto MCACC Speaker Channels Subwoofer Height Speaker Zone B Speaker Zone B Output Level Bi -Amp 7.1 ch Yes - - - - - Fixed No Select how many speakers you have. ENTER Next The image on the screen changes as you choose the number of channels in "Speaker Channels", so refer to it when performing the settings. 77 Front Panel≫ Rear Panel≫ Remote≫