Pioneer VSX-D309 Owner's Manual - Page 30

Sound Modes Sound Selecting a Sound Mode To ensure the best possible surround sound, be sure to complete the set up procedures described in "Setting Up for Surround Sound" (starting on page 14) before using the sound modes. This is particularly important when using the 2 (Dolby) sound mode. DSP mode 1 Press RECEIVER. Î MULTI CONTROL DVD/LD TV/SAT VCR/DVR CD This sets the remote to select the sound mode. (You can skip this step when using the controls on the receiver.) 1 RECEIVER TUNER CD-R/ TAPE/MD TV CONT 2 Press DSP MODE to select the sound mode. 2 2 DSP MODE MIDNIGHT 5.1CH 1 2 3 4 CHANNEL TEST SIGNAL SELECT TONE ATT SELECT Each press changes the DSP mode as follows: 5 6 7 8 CHANNEL LEVEL EFFECT 9 0 ‡ ENTER 10 DISC =HALL 1 = HALL 2 = JAZZ = DANCE CH FUNC EFFECT VOL TV CONTROL VOL FQ +/- THEATER 2 + THEATER 1 + ST MENU ST ENTER TOP MENU FQ SOURCE CLASS MPX BAND 7 8 3 D.ACCESS 1¡ CHANNEL 4¢ LOUDNESS FUNCTION MUTING memo The amount of effect of each DSP mode can be adjusted in the range of 10 to 90 (the default setting is 70) by pressing EFFECT +/-. DSP MODE RECEIVER FL DIMMER REMOTE SETUP MASTER VOLUME AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT DVD 5.1 ch. input playback Connect a DVD player with 5.1 channel output to enjoy the surround sound created by 5.1 channel playback. DVD / LD MULTI CONTROL RECEIVER Î MULTI CONTROL DVD/LD TV/SAT VCR/DVR CD RECEIVER TUNER CD-R/ TAPE/MD TV CONT 2 DSP MODE MIDNIGHT 5.1CH 1 2 3 4 CHANNEL TEST SELECT TONE 5 6 SIGNAL ATT SELECT 7 8 CHANNEL LEVEL 9 0 EFFECT ‡ ENTER 10 DISC CH There are two ways to switch on DVD 5.1 CH mode. With the remote control press the DVD/ LD MULTI CONTROL button. Then press the RECEIVER button and number button 4 (DVD 5.1CH). On the main unit simply press the DVD 5.1CH button. DVD 5.1CH Press number button 4 (DVD 5.1CH) on the remote to go back to the DVD/LD mode control To exit this mode using the main unit simply press other function button (DVD/LD, etc.). DVD 5.1CH 30 dB memo • When 5.1 ch input is selected, Dolby mode, DSP mode,SIGNAL SELECT, ATT, DIRECT, TONE, MIDNIGHT mode, LOUDNESS cannot be operated. • When 5.1ch input is selected, only the volume level and channel levels can be set.