Pioneer VSX-D510 Owner's Manual - Page 26

07 Using the Tuner Finding a Station The following steps show you how to tune in to FM and AM radio broadcasts using the automatic (search) and manual (step) tuning functions. If you already know the exact frequency of the station you want to listen to, see Tuning Directly to a Station below. Once you are tuned to a station you can memorize the frequency for recall later-see Memorizing Stations on page 27 for more on how to do this. 1 MULTI CONTROL DVD/LD TV/SAT VCR/DVR CD RECEIVER TUNER CD-R/ TAPE/MD TV CONT 2 DSP MODE MIDNIGHT 5.1CH 1 2 3 4 CHANNEL TEST SELECT TONE 5 6 SIGNAL ATT SELECT 7 8 CHANNEL LEVEL 9 0 EFFECT ‡ ENTER FUNC 10 DISC CH VOL TV CONTROL VOL FQ ST MENU ST ENTER TOP MENU FQ SOURCE CLASS MPX BAND 7 8 3 D.ACCESS 1¡ CHANNEL 4¢ LOUDNESS FUNCTION MUTING RECEIVER FL DIMMER REMOTE SETUP MASTER VOLUME 3 2 MPX 1 Press the MULTI CONTROL TUNER button on the remote control or turn the MULTIJOG DIAL on the receiver to select the tuner mode. 2 Use the BAND button to change the band (FM or AM), if necessary. Each press switches the band between FM and AM. 3 Tune to a station. Automatic tuning To search for stations in the currently selected band, press and hold either the FQ. + or FQ. - button for about a second. The receiver will start searching for the next station, stopping when it has found one. Repeat this step to search for other stations. Manual tuning To change the frequency one step at a time, press the FQ. + / FQ. - (5∞) buttons. High speed tuning Press and hold the FQ. + or FQ. - button for high speed tuning, releasing the button once the desired frequency is reached. Tuning Directly to a Station Sometimes, you'll already know the frequency of the station you want to listen to. In this case, you can simply enter the frequency directly using the number buttons on the remote control (this function is not available using the front panel controls of the receiver). 1 3 MULTI CONTROL DVD/LD TV/SAT VCR/DVR CD RECEIVER TUNER CD-R/ TAPE/MD TV CONT 2 DSP MODE MIDNIGHT 5.1CH 1 2 3 4 CHANNEL TEST SELECT TONE 5 6 SIGNAL ATT SELECT 7 8 CHANNEL LEVEL 9 0 EFFECT ‡ ENTER FUNC 10 DISC CH VOL TV CONTROL VOL FQ ST MENU ST ENTER TOP MENU FQ SOURCE CLASS MPX BAND 7 8 3 D.ACCESS 1¡ CHANNEL 4¢ LOUDNESS FUNCTION MUTING FL REMOTE MASTER 4 2 1 Press the MULTI CONTROL TUNER button on the remote control or turn the MULTIJOG DIAL on the receiver to select the tuner mode. 2 Press the BAND button to select either FM or AM. Each press switches the band between FM and AM. 3 Press D.ACCESS (DIRECT ACCESS). 4 Use the number buttons to enter the frequency of the radio station. Example: To tune to 106.00 (FM), press 1 - 0 - 6 - 0 - 0 SP A TUNED STEREO MEMO: • If you make a mistake while inputting the frequency, press the D.ACCESS button twice to cancel the frequency and start again. MPX mode If the TUNED or STEREO indicators don't light when tuning to an FM station because the signal is weak, press the MPX button to switch the receiver into mono reception mode. This should improve the sound quality and allow you to enjoy the broadcast. 26 En