Polaroid XD221U-G User Manual - Page 20

Menu operation (continued) 2. INSTALLATION menu Menu option WALL SCREEN LAMP MODE STANDBY MODE AUDIO INPUT AUTO POWER ON AUTO POWER OFF SPLASH SCREEN BACK COLOR IMAGE REVERSE LAMP TIME RESET Setting OFF/BEIGE / LIGHT BLUE / LIGHT GREEN / PINK / BLACK BOARD/WHITE BOARD STANDARD LOW STANDARD LOW AUTO AUDIO 1/AUDIO 2 MIX ON/OFF OFF/5-60 min ON/OFF BLUE/BLACK OFF MIRROR INVERT MIRROR INVERT OK Feature description Selects a desired setting based on the color of the screen or wall on which images are projected. (See page 15.) When selecting a setting other than BLACK BOARD/WHITE BOARD, you can fine-tune the color tone to the desired level on the 1 to 5 scale. Select this setting when you want to view images in a well-lit room. Select this setting when you want to view images at a moderate light intensity. The operating sound is consequently reduced, and the lamp lifetime becomes longer. • When this mode is switched, projected images may flicker. • If this mode is frequently switched, the lamp may be deteriorated. LAN and MONITOR OUT can be activated in STANDARD MODE. Power consumption can be lowered when selecting LOW. However, LAN and MONITOR OUT cannot be activated. If AUTO is selected, selects AUDIO 1 when the input source is COMPUTER, while selects AUDIO 2 when the input source is VIDEO/SVIDEO. Select the audio input. Selects MIX signal of AUDIO 1 and AUDIO 2. You can change the balance of AUDIO 1/AUDIO 2 using MIX . When this mode is set to ON, the lamp is automatically lit when the power cord is plugged in the wall outlet. Select ON when you set the projector at the ceiling. • When the lamp is off, the projector is in standby. Use the remote control to turn on the lamp. Selects a desired timer setting until the projector enters the standby mode when there is no signal input from the source. Select ON to display the splash screen when the projector is powered on. Selects the background color that is displayed when there is no signal input from the source. Select this setting when you want to view images from the front with the projector set on the floor. Select this setting when you want to view images from behind the screen with the projector set on the floor. Select this setting when you want to view images from behind the screen with the projector set at the ceiling. Select this setting when you want to view images from the front with the projector set at the ceiling. Resets LAMP TIME. opt. INSTALLATION WALL SCREEN LAMP MODE STANDBY MODE AUDIO INPUT AUTO POWER ON AUTO POWER OFF ON SPLASH SCREEN BACK COLOR IMAGE REVERSE LAMP TIME RESET BEIGE STANDARD STANDARD AUTO OFF OFF ON BLUE OFF OK • By default, the LAMP MODE is set to STANDARD. The LAMP MODE is set to either STANDARD or LOW depending on the setting last selected, and you cannot switch the LAMP MODE in about one minute after the lamp is on. EN-20