Poulan 225114X92E1 User Manual - Page 15

TROUBLESHOOTING - See appropriate section in manual unless directed to a qualified service center. PROBLEM CAUSE CORRECTION Loss of power 1. Rear of mower housing or blade dragging in grass. 2. Cutting too much grass. 3. Dirty air filter. 4. Buildup of grass, leaves, and trash under mower. 5. Too much oil in engine. 6. Walking speed too fast. 1. Raise cutting height. 2. Raise cutting height. 3. Clean/replace air filter. 4. Clean underside of mower housing. 5. Check oil level. 6. Cut at slower walking speed. Poor cut - uneven 1. Worn, bent or loose blade. 2. Wheel heights uneven. 3. Buildup of grass, leaves and trash under mower. 1. Replace blade. Tighten blade bolt. 2. Set all wheels at same height. 3. Clean underside of mower housing. Excessive vibration 1. Worn, bent or loose blade. 2. Bent engine crankshaft. 1. Replace blade. Tighten blade bolt. 2. Contact a qualified service center. Starter rope hard to pull 1. Engine flywheel brake is on 1. Depress control bar to when control bar is released. upper handle before pulling the starter rope. 2. Bent engine crankshaft. 2. Contact a qualified service center. 3. Blade adapter broken. 3. Replace blade adapter. 4. Blade dragging in grass. 4. Move lawn mower to cut grass or to hard surface. Grass catcher not filling (If so equipped) 1. Cutting height too low. 2. Lift on blade worn off. 3. Catcher not venting air. 1. Raise cutting height. 2. Replace blade. 3. Clean grass catcher. Hard to push 1. Grass is too high or wheel height is too low. 2. Rear of mower housing or blade dragging in grass. 3. Grass catcher too full. 4. Handle height position not right for you. 1. Raise cutting height. 2. Raise rear of mower housing one (1) setting higher. 3. Empty grass catcher. 4. Adjust handle height to suit. 15