Poulan BC2400P User Manual - Page 9

S Wind the line evenly and tightly onto the spool. Wind in the direction of the arrows found on the spool. S Push the lines into the notches, leaving 3 to 5 inches (7 -- 12 cm) unwound. S Insert the lines into the the exit holes in the hub as shown in the illustration. S Align notches with the line exit holes. S Push the spool into the hub until it snaps into place. S Pull the lines extending outside of the hub to release the lines from the notches. CARBURETOR ADJUSTMENT Your carburetor is equipped with limiter caps. Damage will occur if you turn the needles beyond the limiter caps. Adjusting the carburetor is a complicated task. We recommend that you take your unit to an Authorized Service Dealer. SPARK PLUG Replace spark plug yearly with a Champion RCJ-8Y plug. Spark plug gap is 0.025 inch. IGNITION TIMING Ignition timing is fixed, non-adjustable. SERVICE We recommend all service and adjustments not listed in this manual be performed by an Authorized Service Dealer. NEED ASSISTANCE? NEED ASSISTANCE? Call 1-800-554-6723. NEED SERVICE PART? Contact your dealer. TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit. TROUBLE CAUSE REMEDY Engine will not S Engine flooded. start. S Fuel tank empty. S Spark plug not firing. S Fuel not reaching carburetor. S See "Starting." S Fill tank with correct fuel mixture. S Install new spark plug. S Check for dirty fuel filter; replace. Check for kinked or split fuel line; repair or replace. S Carburetor requires adjustment. S See "Carburetor Adjustments." Engine will not S Carburetor requires adjustment. S See "Carburetor Adjustments." idle properly. S Throttle trigger screw too S Loosen screw. tight. Engine will not S Air filter dirty. S Clean or replace air filter. accelerate, S Spark plug fouled. S Clean or replace spark plug; re-gap. lacks power, S Carburetor requires adjustment. S See "Carburetor Adjustments." or dies under a load. Engine smokes excessively. S Fuel mixture incorrect. S Empty fuel tank and refill with correct fuel mixture. S Air filter dirty. S Clean or replace air filter. S Carburetor requires adjustment. S See "Carburetor Adjustments." Line does not advance or breaks while cutting. S Line improperly routed in head. S Line improperly wound on spool. S Line size incorrect. S Check line routing. S Rewind line tightly and evenly. S Use only 0.080" (2 mm) dia. line. Line welds onto spool. S Line size incorrect. S Incorrect spool. S Line is being crowded against material being cut. S Use only 0.080" (2 mm) dia. line. S Replace with correct spool. S Cut with tip of line fully extended. Line pulls back into head. S Too little line outside of head. S Line size incorrect. S Remove spool and pull 4 inches (10 cm) of line outside of head. S Use only 0.080" (2 mm) dia. line. 9