Poulan CHD145H42B User Manual - Page 20
Replace, Mower, Blade, Drive
View all Poulan CHD145H42B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
SERVICE AND ADJUSTMENTS FRONT-TO-BACK ADJUSTMENT (See Figs. 23 and 24) IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TOSIDE. To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position. Check adjustment on right side of tractor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown. • Before making any necessary adjustments, check that both front links are equal in length. Both links should be approximately 10-3/8". • If links are not equal in length, adjust one link to same length as other link. • To lower front of mower loosen nut "E" on both front links an equal number of turns. • When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nuts "F" against trunnion on both front links. • To raise front of mower, loosen nut "F" from trunnion on both front links. Tighten nut "E" on both front links an equal number of turns. • When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nut "F" against trunnion on both front links. • Recheck side-to-side adjustment. MANDREL TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 25) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake. BELT REMOVAL - • Remove mower from tractor (See "TO REMOVE MOWER" in this section of this manual). • Work belt off both mandrel pulleys and idler pulleys. • Pull belt away from mower. BELT INSTALLATION - • Install new belt in reverse order of removal. • Make sure belt is in all pulley grooves and inside all belt guides. • Install mower in reverse order of removal instructions. MANDREL PULLEY IDLER PULLEYS 4.• MANDREL PU EY FIG. 25 FIG. 23 BOTH FRONT LINKS MUST BE EQUAL IN LENGTH O NUT "F" NUT "E" FRONT LINKS 0 TRUNNION FIG. 24 20