Poulan ES400 User Manual - Page 7

ASSEMBLY WARNING: Before using chain saw, ensure all fasteners are secure. CARTON CONTENTS S Chain Saw (fully assembled) S Bar Sheath Examine parts for damage. Do not use damaged parts. NOTE: If you need assistance or find that parts are missing or damaged, please call 1-800-554-6723. ASSEMBLY Your unit is fully assembled; no assembly is required. OPERATION KNOW YOUR SAW READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Bar Oil Cap Trigger Lockout Button Handguard Power Cord Bar Bar Knob Bar Trigger Clamp Chain Switch Adjusting Wheel Chain TRIGGER SWITCH The TRIGGER SWITCH is used to turn on the unit. Squeeze the trigger switch to operate the unit after lock--out button has been pushed forward. Release the trigger to turn the unit off. TRIGGER LOCK--OUT BUTTON The TRIGGER LOCK--OUT BUTTON is a control feature designed to prevent the motor from being accidently started. When the rear handle is gripped in a normal cutting position, the lock--out button can be pushed in by the thumb, permitting the index finger to squeeze the trigger. It is not necessary to maintain pressure on the lock--out button once the trigger has been engaged. BAR OIL CAP The BAR OIL CAP is used to fill the bar oil tank. CHAIN ADJUSTING WHEEL The CHAIN ADJUSTMENT WHEEL is used to adjust the chain tension. POWER CORD The POWER CORD is used to connect the chain saw to an approved extension cord. CHAIN TENSION It is normal for a new chain to stretch during first 15 minutes of operation. You should check your chain tension frequently. See CHAIN TENSION under the SERVICE AND ADJUSTMENTS section. OPERATING INSTRUCTIONS Use only a voltage supply as specified on your unit. SELECT AN EXTENSION CORD MINIMUM WIRE GAUGE RECOMMENDATIONS Volts 25 ft. (7.67 m) 50 ft. (15.24 m) 100 ft. (30.48 m) 120 14 A.W.G.* 12 A.W.G.* NOT RECOMMENDED *American Wire Gauge ATTACH THE EXTENSION CORD TO YOUR CHAIN SAW To prevent disconnection from unit, secure extension cord to power cord as shown in the following illustration. Power Cord Extension Cord 7