Poulan HDF550L User Manual - Page 5

ASSEMBLY UNPACK CARTON & INSTALL HANDLE (See Fig. 2) CAUTION: Becarefulofexposedstaples whenhandling or disposing of cartoning material. IMPORTANT: WHEN UNPACKING AND ASSEMBLING TILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLE(S). • Cut cable ties securing handles. • Slowly lift handle assembly up, route cable(s) as shown and align handle holes with handle panel hole and slot. • Loosely assemble hardware as shown. Be sure the shorter(3/4" long) hex boltis assembled inlowerholeof handle. Repeat foropposite side. Tightenallhardware securely. • Cut cable ties securing tiller to skid and remove tiller from skid. • Remove screws securing depth stake to skid and discard the screws. LOCK NUT WASHER TILLER HANDLE HANDLE PANEL 0 FLAT WASHER HEX BOLT 5/16-18X1" HEX BOLT 5/16-18X3/4" CABLE(S) TILLER HANDLES HANDLE PANEL BOLTS it INSTALL DEPTH STAKE ASSEMBLY Loosen nut "A". • Insert stake support between engine bracket halves with stake spring down. Bolt stake support to engine brackets with bolts, lock washers and nuts. Tighten securely. Tighten nut "A". • Depth stake must move freely. If it does not, loosen support bolt. ENGINE BRACKET HALVES NUT "A" DEPTH STAKE DEPTH STAKE SUPPORT SUPPORT BOLT HEX BOLTS, LOCK WASHERS, AND HEX NUTS STAKE SPRING FIG. 3 HANDLE HEIGHT • Handle height may be adjusted to better suit operator. (See "HANDLE HEIGHT" in the Service and Adjustments section of this manual). TILLING WIDTH • Tilling width may be adjusted to better handle yourtilling conditions (See "TINE ARRANGEMENT" in the Service and Adjustments section of this manual). TINE OPERATION • Check tine operation before first use. (See "TINE OPERATION CHECK" in the Service and Adjustments section of this manual). FIG. 2 5