Poulan PB19542LT User Manual - Page 7

ASSEMBLY INSTALL SEAT (See Figs. 2A and 2B) • Remove bolt and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. Remove the cardboard packing and discard. • Connect switch to seat. • Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan. CHECK BATTERY (See Fig. 3) • Lift seat pan to raised position. • If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions). SEAT SWITCH PAD SLOT SEAT PAN TAPE WIRING HARNESS Fig. 2A • Push down on seat to engage pads in slots and pull seat towards rear of tractor. • Raise seat and tighten bolt securely. • Remove tape and discard. • Lower seat into operating position and sit on seat. Press clutch/brake pedal all the way down. If operating position is not comfortable, adjust seat. To adjust seat: Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle. SLOT PAD FLAT WASHER TAPE SEAT PAN LABEL TERMINAL TERMINAL Fig. 3 NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid. WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects. TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls) • Press lift lever plunger and raise attachment lift lever to its highest position. • Release parking brake by depressing clutch/brake pedal. • Place gearshift lever in neutral (N) position. • Roll tractor forward off skid. • Remove banding holding the deflector shield up against tractor. SEAT PAN BOLT TAB Fig. 2B ADJUSTMENT HANDLE 7