Poulan PD17542LT User Manual - Page 7

ASSEMBLY SEAT PAN SEAT SHOULDER BOLT 2466 FLAT WASHER LOCK WASHER 02465 ADJUSTMENT BOLT FIG. 2 CHECK BATTERY (See Fig. 3) • Lift seat pan to raised position. • If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions). SEAT PAN LABEL NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid. TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls) • Press lift lever plunger and raise attachment lift lever to its highest position. • Release parking brake by depressing clutch/brake pedal. • Place gearshift lever in neutral (N) position. • Roll tractor forward off skid. • Remove banding holding deflector shield up against tractor. TO DRIVE TRACTOR OFF SKID (See Operation section for location and function of controls) WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects. • Be sure all the above assembly steps have been completed. • Check engine oil level and fill fuel tank with gasoline. • Sit on seat in operating position, depress clutch/brake pedal and set the parking brake. • Place gear shift lever in neutral (N) position. • Press lift lever plunger and raise attachment lift lever to its highest position. • Start the engine.After engine has started, move throttle control to idle position. • Depress clutch/brake pedal into full "BRAKE" position and hold. Move gearshift lever to 1st gear. • Slowly release clutch/brake pedal and slowly drive tractor off skid. • Apply brake to stop tractor, set parking brake and place gearshift lever in neutral position. • Turn ignition key to "OFF" position. Continue with the instructions that follow. TERMINAL TERMINAL FIG. 3 7