Poulan PD25PH48STE User Manual - Page 8

ASSEMBLY TO ATTACH NOSE ROLLER (See Fig. 5) • Assemble brackets "A" and "B" to the inside of mower mounting brackets as shown. Tighten securely. NOTE: Be sure bracket tabs are positioned in tab holes in mower brackets. • Position nose roller between brackets and install rod and retainer spring. LOCK NUT HEX BOLT ROD TAB HOLE "B" BRACKET "A" BRACKET 02612 RETAINER SPRING NOSE ROLLER FIG. 5 INSTALL MOWER AND DRIVE BELT (See Figs. 6 and 7) Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage parking brake. • Cut and remove ties securing anti-sway bar and belts. Swing anti-sway bar to left side of mower deck. • Slide mower under tractor with deflector shield to right side of tractor. IMPORTANT: Check belt for proper routing in all mower pulley grooves. • If equipped, turn height adjustment knob counterclockwise until it stops. • Lower mower linkage with attachment lift control. • Be sure belt tension rod is in disengaged position. Install belt into electric clutch pulley groove. • Place the suspension arms on outward pointing deck pins. Retain with double loop retainer spring with loops up as shown. • Install front plate assembly to tractor suspension brackets and retain with single loop retainer springs as shown. • Position front plate assembly between front mower brackets. Raise deck and plate assembly to align holes and insert flanged pins. Secure pins with double loop retainer springs between the plate assembly and mower brackets. NOTE: To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower side-to-side to give space between plate and mower brackets. IMPORTANT: Check belt for proper routing in all mower pulley grooves. Engage belt tension rod by pushing rod into locking bracket. • Engage belt tension rod by pushing rod into locking bracket. CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly. • Connect anti-sway bar to chassis bracket under left footrest and retain with double loop retainer spring. • If equipped, turn height adjustment knob clockwise to remove slack from mower suspension. • Raise deck to highest position. • Adjust gauge wheels before operating mower as shown in the Operation section of this manual. LOCK BRACKET BELT TENSION ROD (DISENGAGED POSITION) CHASSIS BRACKET ELECTRIC CLUTCH FRONT SUSPENSION PULLEY FRONT BRACKETS MOWER BRACKET DOUBLE LOOP RETAINER SPRING FRONT PLATE ASSEMBLY GAUGE WHEEL DOUBLE LOOP RETAINER SPRING USE PLIERS FOR RETAINER SPRINGS ANTI-SWAY BAR SUSPENSION ARMS DOUBLE LOOP RETAINER LOOP UP SPRING (OUTWARD POINTING DECK PINS) 02510 FIG. 6 8 FLANGED PIN SINGLE LOOP RETAINER SPRINGS DEFLECTOR SHIELD