Poulan PO15538C User Manual - Page 22
To Replace Headlight Bulb, Interlocks And Relays, To Replace Fuse, Replacing Battery See Figs. 23
View all Poulan PO15538C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
SERVICE AND ADJUSTMENTS TO REMOVE CABLES, REVERSE ORDER • BLACK cable first from chassis and then from the fully charged battery. • RED cable last from both batteries. TERMINAL COVER KEPS NUT HEX BOLT WEAK OR DEAD BATTERY 02614 FULLY CHARGED BATTERY FIG. 22 REPLACING BATTERY (See Figs. 23 and 24) WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding. • Lift seat pan to raised position. • Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor. • Install new battery with terminals in same position as old battery. • First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal. • Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely. 02603 POSITIVE (RED) CABLE FIG. 24 NEGATIVE (BLACK) CABLE TO REPLACE HEADLIGHT BULB • Raise hood. • Pull bulb holder out of the hole in the backside of the grill. • Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. • Close hood. INTERLOCKS AND RELAYS Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting. • Check wiring. See electrical wiring diagram in the Repair Parts section. TO REPLACE FUSE Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash. SEAT PAN 02602 FIG. 23 22