Poulan PP115E27 User Manual - Page 9

GASOLINE FILLER CAP MUFFLER CHOKE CONTROL PRIMER SAFETY IGNITION KEY ON / OFF SWITCH NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. OPERATION ELECTRIC START BUTTON RECOIL (AUXILIARY) STARTER HANDLE AUGER CONTROL LEVER CHUTE DEFLECTOR DISCHARGE CHUTE DRIVE CONTROL LEVER SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER TRACTION DRIVE CONTROL LEVER DISCHARGE CHUTE CLEAN-OUT TOOL LIGHT HANDLE KNOB MUFFLER TOOLBOX SKID PLATE AUGERS FIG. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Electric start button - used for starting the engine. Recoil (auxiliary) starter handle - used for starting the engine. Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Choke control - used for starting a cold engine. ON / OFF switch - used to STOP the engine. Traction drive control lever - used to engage powerpropelled forward or reverse motion of snow thrower. Auger control lever - used to engage auger motion (throw snow). Deflector remote control lever - used to change the distance the snow is thrown. Discharge chute control lever - used to change the direction the snow is thrown. Skid plate - used to adjust height of scraper bar from the ground. 9