Poulan PP165E30 User Manual - Page 9
Meets A.n.s.i. Safety Requirements, On / Off Switch
View all Poulan PP165E30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
GASOLINE FILLER CAP MUFFLER CHOKE CONTROL PRIMER SAFETY IGNITION KEY ON / OFF SWITCH OPERATION ELECTRIC START BUTTON RECOIL (AUXILIARY) STARTER HANDLE AUGER CONTROL LEVER CHUTE DEFLECTOR DISCHARGE CHUTE DRIVE CONTROL LEVER SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER TRACTION DRIVE CONTROL LEVER LH TURN TRIGGER DISCHARGE CHUTE LIGHT CLEAN-OUT TOOL HANDLE KNOB NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. MUFFLER TOOLBOX DRIFT CUTTER SKID PLATE AUGERS FIG. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Traction drive control lever - used to engage powerpropelled forward or reverse motion of snow thrower. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Auger control lever - used to engage auger motion (throw snow). Electric start button - used for starting the engine. Recoil (auxiliary) starter handle - used for starting the engine. Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. LH and RH turn triggers - used to steer the snow thrower. Choke control - used for starting a cold engine. Deflector remote control lever - used to change the distance the snow is thrown. Discharge chute control lever - used to change the direction the snow is thrown. Skid plate - used to adjust height of scraper bar from the ground. Drift cutter - used to cut through deep snowdrifts. ON / OFF switch - used to STOP the engine. 9