Poulan PP524B User Manual - Page 9

OPERATION SAFETY IGNITION KEY SPARK PLUG CHOKE CONTROL THROTTLE / ENGINE CONTROL RECOIL STARTER HANDLE PRIMER ENGINE OIL CAP AUGER DISCHARGE CHUTE CONTROL LEVER WITH DIPSTICK CONTROL LEVER DRIVE SPEED CONTROL LEVER GASOLINE FILLER CAP CHUTE DEFLECTOR TRACTION DRIVE CONTROL LEVER OIL DRAIN PLUG DISCHARGE CHUTE FUEL SHUT-OFF VALVE CLEAN-OUT TOOL HANDLE KNOB NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. MUFFLER TOOLBOX AUGERS SKID PLATE FIG. 8 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Recoil starter handle - used for starting the engine. Auger control lever - used to engage auger motion (throw Primer - pumps additional fuel from the carburetor to the snow). cylinder for use when starting a cold engine. Discharge chute control lever - used to change the di- Throttle/engine control - used to select either FAST or rection the snow is thrown. SLOW engine speed and to STOP the engine. Skid plate - used to adjust height of scraper bar from the Choke control - used for starting a cold engine. ground. 9