Poulan PP7527ES User Manual - Page 4

PARTS PACKED SEPARATELY IN CARTON ASSEMBLY / PRE-OPERATION Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower. Your new snow thrower has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts bag. To ensure safe and proper operation of your snow thrower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness. speed control rod to lower handle. 4. Remove snow thrower from carton and check carton thoroughly for additional loose parts. HOW TO SET UP YOUR SNOW THROWER TOOL BOX (See Fig. 8) A toolbox is provided on your snow thrower. The toolbox is located on top of the belt cover. Store the extra shear bolts, nuts and multi-wrench provided in parts bag in the toolbox. REMOVE SNOW THROWER FROM CARTON NOTE: The multi-wrench may be used for assembly of the chute rotator head to snow thrower and making adjustments 1. Remove all accessible loose parts and parts boxes to the skid plates. from carton. UNFOLD UPPER HANDLE 2. Cut down all four corners of carton and lay panels flat. 1. Raise upper handle to the operating position and tighten 3. Remove all packing materials except plastic tie holding 4 handle knobs securely.