Poulan PP800EPS24 User Manual - Page 9
Meets A.n.s.i. Safety Requirements, On / Off Switch
View all Poulan PP800EPS24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
GASOLINE FILLER CAP MUFFLER CHOKE CONTROL PRIMER SAFETY IGNITION KEY ON / OFF SWITCH NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. OPERATION ELECTRIC AUGER DISCHARGE CHUTE START BUTTON CONTROL CONTROL LEVER LEVER RECOIL (AUXILIARY) DRIVE SPEED CONTROL LEVER STARTER HANDLE CHUTE DEFLECTOR DEFLECTOR REMOTE CONTROL LEVER TRACTION DRIVE CONTROL LEVER DISCHARGE CHUTE LH TURN TRIGGER LIGHT CLEAN-OUT TOOL HANDLE KNOB MUFFLER TOOLBOX AUGERS SKID PLATE Fig. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Electric start button - used for starting the engine. LH and RH turn triggers - used to steer the snow thrower. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Recoil (auxiliary) starter handle - used for starting the engine. Auger control lever - used to engage auger motion (throw snow). Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Discharge chute control lever - used to change the direction the snow is thrown. ON / OFF switch - used to STOP the engine. Choke control - used for starting a cold engine. Skid plate - used to adjust height of scraper bar from the ground. 9