Poulan PPB3000B User Manual - Page 6

INSTALLING ATTACHMENT 1. Remove the shaft cap from the attach- ment (if present) and discard. 2. Position locking/release button of attach- ment into guide recess of upper shaft coupler. 3. Push the attachment into the coupler until the locking/release button snaps into the primary hole. 4. Before using the unit, tighten the knob securely by turning clockwise. Coupler Primary Hole Guide Recess INSTALLING ATTACHMENT HANGER An attachment hanger is provided for storage when attachment is not in use. To install hanger on attachment: 1. Remove the shaft cap from the attach- ment (if present) and discard. 2. Press and hold the locking/release but- ton. 3. Push hanger onto the attachment until the locking/release button snaps into the hole. OPERATING POSITION ALWAYS WEAR: Eye Protection Upper Shaft Locking/ Release Attachment Button WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before operating the unit. Using the wrong hole could lead to serious injury or damage to the unit. Locking/Release Button in Primary Hole WARNING: Inspect the area before using the unit. Remove all debris and hard objects such as rocks, glass, wire, etc., that can ricochet, be thrown, or otherwise cause injury or damage during operation. Use your blower attachment for: S Sweeping debris or grass clippings from driveways, sidewalks, patios, etc. S Blowing grass clippings, straw, or leaves into piles, or removing debris from corners, around joints, or between bricks. Control air flow by directing the blower dis- charge opening down or to one side. Always work away from solid objects such as walks, large stones, vehicles, and fences. Clean corners by starting in corners and moving outward. This will help prevent an accumulation of debris which could fly into your face. Be careful when working near plants. The force of the air could damage tender plants. MAINTENANCE WARNING: Always stop unit and dis- connect spark plug wire (or disconnect powerhead from power source) before performing maintenance. CHECK FOR LOOSE FASTENERS AND PARTS S Housing Screws INSPECT AND CLEAN UNIT AND LABELS S After each use, inspect complete unit for loose or damaged parts. Clean the unit and labels using a damp cloth with a mild deter- gent. S Wipe off unit with a clean dry cloth. -- 6 --