Poulan PPCRT55 User Manual - Page 5

ASSEMBLY UNPACKING CARTON (See Fig. 2) CAUTION: Be careful of exposed staples when handling or disposing of cartoning material. IMPORTANT:WHEN UNPACKING AND ASSEMBLINGTILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLES. • While holding handle assembly, cut cable ties securing handle assembly to top frame and depth stake. Let handle assembly rest on tiller. • Remove top frame of carton. • Slowly ease handle assembly up and place on top of carton. • Cut down right hand front and right hand rear corners of carton, lay side carton wall down. • Remove packing material from handle assembly. SHIFT ROD carton_1 HANDLE ASSEMBLY FIG. 2 INSTALL HANDLE (See Figs. 3, 4, and 5) • Insert one handle lock (with teeth facing outward) in gearcase notch. (Apply grease on smooth side of handle lock to aid in keeping lock in place until handle assembly is lowered into position.) VIEWED FROM R.H. SIDE OF TILLER HANDLE ASSEMBLY GEARCASE NOTCH HANDLE LOCK HANDLE ASSEMBLY "UP" POSITION TIGHTEN HANDLE LOCK LEVER TO HOLD LOOSEN HANDLE LOCK LEVER TO MOVE FIG. 4 • Rotate handle assembly down. Insert rear carriage bolt first, with head of bolt on L.H. side of tiller and loosely assemble locknut (See Fig. 5). • Insert pivot bolt in front part of plate and tighten. • Cut down remaining corners of carton and lay panels flat. • Lower the handle assembly. Tighten nut on carriage bolt so handle moves with some resistance. This will allow for easier adjustment. • Place flat washer on threaded end of handle lock lever. • Insert handle lock lever through handle base and gearcase. Screw in handle lock lever just enough to hold lever in place. • Insert second handle lock (with teeth inward) in the slot of the handle base (just inside of washer). • Raise handle assembly to highest position and securely tighten handle lock lever by rotating clockwise. Leaving handle assembly in highest position will make it easier to connect shift rod. GEARCASE SLOT HANDLE LOCK FLAT WASHER HANDLE LOCK LEVER CARRIAGE BOLT FIG. 3 • Grasp handle assembly. Hold in "up" position. Be sure handle lock remains in gearcase notch. Slide handle assembly into position. 5 handles_34 HANDLE BASE PIVOT BOLT LOCKNUT FIG. 5