Poulan PR17H42STF User Manual - Page 11

OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. HOW TO USE YOUR TRACTOR TO SET PARKING BRAKE (See Fig. 6) Your tractor is equipped with an operator presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine. • Depress clutch/brake pedal into full "BRAKE" position and hold. • Place parking brake lever in "ENGAGED" position and release pressure from clutch/brake pedal. Pedal should remain in "BRAKE" position. Make sure parking brake will hold tractor secure. THROTTLE/CHOKE CONTROL LEVER ATTACHMENT CLUTCH LEVER "ENGAGED" POSITION "BRAKE" POSITION IGNITION KEY "DISENGAGED" POSITION PARKING BRAKE "ENGAGED" POSITION CLUTCH/BRAKE PEDAL "DRIVE" HEIGHT POSITION ADJUSTMENT KNOB MOTION CONTROL LEVER PARKING BRAKE "DISENGAGED" POSITION IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY POSITION OTHER THAN "OFF" WILL CAUSE THE BATTERY TO BE DISCHARGED, (DEAD). NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause "browning" of grass. To eliminate this possibility, always stop engine when stopping tractor on grass areas. CAUTION: Always stop tractor completely, as described above, before leaving the operator's position; to empty grass catcher, etc. TO USE THROTTLE CONTROL (See Fig. 6) Always operate engine at full throttle. • Operating engine at less than full throttle reduces the battery charging rate. • Full throttle offers the best bagging and mower perfor- mance. TO MOVE FORWARD AND BACKWARD (See Fig. 6) The direction and speed of movement is controlled by the motion control lever. • Start tractor with motion control lever in neutral (N) position. • Release parking brake. • Slowly move motion control lever to desired position. TO ADJUST MOWER CUTTING HEIGHT (See Fig. 6) FIG. 6 STOPPING (See Fig. 6) MOWER BLADES • To stop mower blades,move attachment clutch lever to "DISENGAGED" position. GROUND DRIVE • To stop ground drive, depress clutch/brake pedal into full "BRAKE" position. • Move motion control lever to neutral (N) position. The cutting height is controlled by turning the height adjustment knob in desired direction. • Turn knob clockwise ( ) to raise cutting height. • Turn knob counterclockwise ( ) to lower cutting height. The cutting height range is approximately 1-1/2" to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed. IMPORTANT: THE MOTION CONTROL LEVER DOES NOT RETURN TO NEUTRAL (N) POSITION WHEN THE CLUTCH/BRAKE PEDAL IS DEPRESSED. ENGINE - • Move throttle control to slow position. NOTE: Failure to move throttle control to slow position and allowing engine to idle before stopping may cause engine to "backfire". • The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth. • For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to desired height. • Turn ignition key to "OFF" position and remove key. Always remove key when leaving tractor to prevent unauthorized use. • Never use choke to stop engine. 11