Poulan PR20PH42STA User Manual - Page 7
TO ROLL TRACTOR OFF SKID See Operation
![]() |
View all Poulan PR20PH42STA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY INSTALL SEAT (See Fig. 3) Adjust seat before tightening adjustment knob. • Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. • Pivot seat upward and remove from the cardboard packing. Remove the cardboard packing and discard. • Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan. • Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor. • Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten. • Lower seat into operating position and sit on seat. • Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down. • Get off seat without moving its adjusted position. • Raise seat and tighten adjustment knob securely. SEAT SEAT PAN SHOULDER BOLT FLAT WASHER TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls) • Press lift lever plunger and raise attachment lift lever to its highest position. • Release parking brake by depressing brake pedal. • Place freewheel control in freewheeling position to disengage transmission (See "TO TRANSPORT" in the Operation section of this manual). • Roll tractor forward off skid. • Remove banding holding deflector shield up against tractor. TO DRIVE TRACTOR OFF SKID (See Operation section for location and function of controls) WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects. • Be sure all the above assembly steps have been completed. • Check engine oil level and fill fuel tank with gasoline. • Place freewheel control in "transmission engaged" posi- tion. • Sit on seat in operating position, depress brake pedal and set the parking brake. • Press lift lever plunger and raise attachment lift lever to its highest position. • Start the engine. After engine has started, move throttle control to idle position. • Release parking brake. • Slowly depress forward drive pedal and drive tractor off skid. • Apply brake to stop tractor and set parking brake. • Turn ignition key to "OFF" position. Continue with the instructions that follow. ADJUSTMENT KNOB FIG. 3 NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid. 7
![](/manual_guide/products/poulan-pr20ph42sta-user-manual-8fab6ac/7.png)