Poulan PR827ES User Manual - Page 9
Meets A.n.s.i. Safety Requirements, On / Off Switch
View all Poulan PR827ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
GASOLINE FILLER CAP MUFFLER CHOKE CONTROL PRIMER SAFETY IGNITION KEY ON / OFF SWITCH NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. OPERATION ELECTRIC AUGER DISCHARGE CHUTE CONTROL LEVER START BUTTON CONTROL LEVER DRIVE SPEED DEFLECTOR REMOTE RECOIL CONTROL LEVER CONTROL LEVER (AUXILIARY) STARTER HANDLE CHUTE DEFLECTOR TRACTION DRIVE CONTROL LEVER DISCHARGE CHUTE CLEAN-OUT TOOL LIGHT HANDLE KNOB MUFFLER TOOLBOX SKID PLATE AUGERS FIG. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Electric start button - used for starting the engine. Recoil (auxiliary) starter handle - used for starting the engine. Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine. Choke control - used for starting a cold engine. ON / OFF switch - used to STOP the engine. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Traction drive control lever - used to engage powerpropelled forward or reverse motion of snow thrower. Auger control lever - used to engage auger motion (throw snow). Discharge chute control lever - used to change the direction the snow is thrown. Skid plate - used to adjust height of scraper bar from the ground Deflector remote control lever - used to change the distance the snow is thrown. 9