Poulan PR8527ESA User Manual - Page 9
Meets A.n.s.i. Safety Requirements
![]() |
View all Poulan PR8527ESA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
SAFETY IGNITION KEY SPARK PLUG CHOKE CONTROL OPERATION ENGINE OIL CAP AUGER DISCHARGE CHUTE CONTROL LEVER WITH DIPSTICK CONTROL LEVER DRIVE SPEED CONTROL LEVER GASOLINE FILLER CAP CHUTE DEFLECTOR TRACTION DRIVE CONTROL LEVER THROTTLE / ENGINE CONTROL OIL DRAIN PLUG RECOIL (AUXILIARY) STARTER HANDLE POWER CORD PLUG ELECTRIC START BUTTON FUEL SHUT-OFF VALVE PRIMER DISCHARGE CHUTE NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. LIGHT HANDLE KNOB MUFFLER TOOLBOX AUGERS SKID PLATE FIG. 8 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Electric start button - used for starting the engine. Choke control - used for starting a cold engine. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Recoil (auxiliary) starter handle - used for starting the engine. Auger control lever - used to engage auger motion (throw snow). Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Discharge chute control lever - used to change the direction the snow is thrown. Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine. Skid plate - used to adjust height of scraper bar from the ground. 9
![](/manual_guide/products/poulan-pr8527esa-user-manual-d2adc18/9.png)