Poulan X1844A User Manual - Page 27
Problem, Cause, Correction
View all Poulan X1844A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
TROUBLESHOOTING POINTS PROBLEM CAUSE Engine continues to run 1. Faulty operator-safety presence control system. when operator leaves seat with attachment clutch engaged CORRECTION 1. Check wiring, switches and connections. If not corrected, contact an authorized service center/ department. Poor cut - uneven 1. Worn, bent or loose blade. 2. Mower deck not level. 3. Buildup of grass, leaves, and trash under mower. 4. Bent blade mandrel. 1. Replace blade. Tighten blade bolt. 2. Level mower deck. 3. Clean underside of mower housing. 4. Replace blade mandrel. Mower blades will not rotate 1. Obstruction in clutch mechanism. 2. Mower drive belt out of adjustment. 3. Worn/damaged mower drive belt. 4. Frozen idler pulley. 5. Frozen blade mandrel. 1. Remove obstruction. 2. Adjust mower drive belt. 3. Replace mower drive belt. 4. Replace idler pulley. 5. Replace blade mandrel. Poor grass discharge 1. Engine speed too slow. 2. Travel speed too fast. 3. Wet grass. 4. Mower deck not level. 5. Low/uneven tire air pressure. 6. Worn, bent or loose blade. 7. Buildup of grass, leaves and trash under mower. 8. Mower drive belt worn or out of adjustment. 9. Blades improperly installed. 1C. Improper blades used. 1. Place throttle control in "FAST' position. 2. Shift to slower speed. 3. Allow grass to dry before mowing. 4. Level mower deck. 5. Check tires for proper air pressure. 6. Replace/sharpen blade. Tighten blade bolt. 7. Clean underside of mower housing. 8. Replace/adjust mower drive belt. 9. Reinstall blades sharp edge down. 10. Replace with blades listed in this manual. Headlight(s) not working (if so equipped) 1. Switch is "OFF". 2. Bulb(s) burned out. 3. Faulty light switch. 4. Loose or damaged wiring. 5. Blown fuse. 1. Turn switch "ON". 2. Replace bulb(s). 3. Check/replace light switch. 4. Check wiring and connections. 5. Replace fuse. Battery will not charge 1. Bad battery cell(s). 2. Poor cable connections. 3. Faulty regulator (if so equipped). 4. Faulty alternator. 1. Replace battery. 2. Check/clean all connections. 3. Replace regulator. 4. Replace alternator. Engine "backfires" when turning engine "OFF" 1. Engine throttle control not set at "SLOW" position for 30 seconds before stopping engine. 1. Move throttle control to "SLOW" position and allow to idle for 30 seconds before stopping engine. 27