ProForm 110 R Bike English Manual - Page 19

HOW TO ADJUST THE DRIVE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, you must remove the right pedal, the shield cover, and the right shield (see the instructions below). Using an adjustable wrench, turn the right pedal counterclockwise and remove it. See the HOW TO ADJUST THE REED SWITCH on page 18 and remove the Shield Cover (12). Next, see the EXPLODED DRAWING near the end of this manual and remove the M4 x 16mm Screws (56) from the Right and Left Shields (38, 39). Then, using a flat screwdriver to release the tabs and the V-clip (27), gently remove the Right Shield. Hold the two M8 Locknuts (57) and loosen the two M8 x 16mm Flat Head Screws (34). Next, loosen the M10 x 35mm Hex Screw (30) until the Drive Belt (23) is tight. Then, hold the M8 Locknuts and tighten the M8 x 16mm Flat Head Screws. 23 34 57 30 Then, reattach the right shield, the top shield, and the right pedal. 19